Varistor Metal Oxide Varistor Products Page 26 Varistor Metal-Oxide Varistor Products

2017 Littelfuse, Inc. Specifications are subject to change without notice. Revised: 09/14/17 Metal-Oxide Varistors (MOVs) Surface Mount Multilayer Varistors (MLVs) > MHS Series Product Dimensions (mm) Note: Avoid metal runs in this area, parts are not recommended for use in applications using Silver (Ag) epoxy paste. D E W L Dimension 0402 Size 0603 Size IN MM IN MM A 0.067 1.700 0.100 2.540 B 0.020 0.510 0.030 0.760 C 0.024 0.610 0.035 0.890 D (max.) 0.024 0.600 0.040 1.000 E 0.01 +/- 0.006 0.25 +/- 0.15 0.015 +/- 0.008 0.4 +/- 0.2 L 0.039 +/- 0.004 1.00 +/- 0.10 0.063 +/- 0.006 1.6 +/- 0.15 W 0.020 +/- 0.004 0.50 +/- 0.10 0.032 +/- 0.006 0.8 +/- 0.15 PAD LAYOUT DEMENSIONS CHIP LAYOUT DIMENSIONS 5.0 6.0 7.0 MAXIMUM TEMPERATURE 260 C 20 - 40 SECONDS WITHIN 5 C PREHEAT ZONE RAMP RATE <3 C/s 60 - 150 SEC > 217 C Lead-free (Pb-free) Soldering Recommendations When using a reflow process, care should be taken to ensure that the MHS chip is not subjected to a thermal gradient steeper than 4 degrees per second; the ideal gradient being 2 degrees per second. During the soldering process, preheating to within 100 degrees of the solder's peak temperature is essential to minimize thermal shock. Once the soldering process has been completed, it is still necessary to ensure that any further thermal shocks are avoided. One possible cause of thermal shock is hot printed circuit boards being removed from the solder process and subjected to cleaning solvents at room temperature. The boards must be allowed to cool gradually to less than 50C before cleaning. Littelfuse offers the Nickel Barrier Termination finish for the optimum Lead-free solder performance. The preferred solder is 96.5/3.0/0.5 (SnAgCu) with an RMA flux, but there is a wide selection of pastes and fluxes available with which the Nickel Barrier parts should be compatible. The reflow profile must be constrained by the maximums in the Lead-free Reflow Profile. For Lead-free wave soldering, the Wave Solder Profile still applies. Note: the Lead-free paste, flux and profile were used for evaluation purposes by Littelfuse, based upon industry standards and practices. There are multiple choices of all three available, it is advised that the customer explores the optimum combination for their process as processes vary considerably from site to site. Lead-free Re-flow Profile Figure 10 Wave Solder Profile Figure 8

Previous Page
Next Page