Tvs Diode Array Spa Diodes Page 62 TVS Diode Array SPA Diodes Catalog

2017 Littelfuse, Inc. Specifications are subject to change without notice. Revised: 02/23/17 TVS Diode Arrays (SPA Diodes) General Purpose ESD Protection - SP1002 Series Electrical Characteristics (T OP = 25C) Parameter Symbol Test Conditions Min Typ Max Units Voltage Drop V D I R =1mA 6.0 9.5 V Reverse Standoff Voltage V RWM I R 1A with 1 I/O at GND 6.0 V Leakage Current I LEAK V R =5V with I/O at GND 0.5 A Clamp Voltage 1 V C I PP =1A, t p =8/20s, Fwd 9.2 13.0 V I PP =2A, t p =8/20s, Fwd 11.2 16.0 V Dynamic Resistance R DYN (V C2 - V C1 ) / (I PP2 - I PP1 ) 2.0 ESD Withstand Voltage 1,2 V ESD IEC61000-4-2 (Contact) 8 kV IEC61000-4-2 (Air) 15 kV Diode Capacitance 1 C D Reverse Bias=0V 6 pF Reverse Bias=2.5V 5 pF Reverse Bias=5V 5 pF Notes: 1 Parameter is guaranteed by device characterization 2 A minimum of 1,000 ESD pulses are applied at 1s intervals Thermal Information Parameter Rating Units Storage Temperature Range -55 to 150C Maximum Junction Temperature 150C Maximum Lead Temperature (Soldering 20-40s) 260C Absolute Maximum Ratings Symbol Parameter Value Units I PP Peak Current (t p =8/20 s) 2 A T OP Operating Temperature -40 to 125C T STOR Storage Temperature -55 to 150C CAUTION: Stresses above those listed in "Absolute Maximum Ratings" may cause permanent damage to the device. This is a stress only rating and operation of the device at these or any other conditions above those indicated in the operational sections of this specification is not implied. Time Temperature T P T L T S(max) T S(min) 25 t P t L t S time to peak temperature Preheat Ramp-up Ramp-down Ramp-do Critical Zone TL to T P Critical Zone TL to T P Reflow Condition Pb - Free assembly Pre Heat - Temperature Min (T s(min) ) 150C - Temperature Max (T s(max) ) 200C - Time (min to max) (t s ) 60 - 180 secs Average ramp up rate (Liquidus) Temp (T L ) to peak 3C/second max T S(max) to T L - Ramp-up Rate 3C/second max Reflow - Temperature (T L ) (Liquidus) 217C - Temperature (t L ) 60 - 150 seconds Peak Temperature (T P ) 260 +0/-5 C Time within 5C of actual peak Temperature (t p ) 20 - 40 seconds Ramp-down Rate 6C/second max Time 25C to peak Temperature (T P ) 8 minutes max. Do not exceed 260C Soldering Parameters

Previous Page
Next Page